Replacement Wheels For Floor Jack

---

Replacement Aluminum Racing Jack Caster Wheels For 3 Ton Floor Jacks (2 Pc Set)

Get R200 on your first order, with a minimum spend of R650.

---

---

Supercheap Auto

Select one or two other products to compare.

---

# Video | Replacement Wheels For Floor Jack

• Replacement Wheels For 3 Ton Floor Jack
• Floor Jack Wheel Kit
• Cast Iron Floor Jack Wheels
• Floor Jack Casters
• Steel Floor Jack Wheels

Replacement Parts For Hydraulic Floor Jack

Rebuilding A Hydraulic Floor Jack

The author fears that the small balls in the valves will be lost and the cylinder will become useless. Even though the balls were not included in the kit, precision steel balls can be purchased from a bike shop in a variety of sizes. The ball sizes in my jack are: 5/16 inch (7.94 mm), 7/32 inch (5.55 mm) and 5/32 inch (3.96 mm). If I turn the body of the jack back and forth, I hear metal balls rolling inside the passages. I placed a pair of pliers under the screw head and pounded the pliers with a hammer to remove the metal plug from the body of the jack. The second photo shows the body of the bottle jack, but reversed so that it is easier to hold when using the camera. When the cylinder's safety range is exceeded, the safety overload valve opens like a pressure regulator to allow oil to return to the reservoir rather than enter the cylinder chamber. To make it at home, I carefully turned this screw and counted half turns until it bottomed out. When reassembling, I will gently turn the screw until it bottoms out, then unscrew it 1 3/4 turns. One author noted that some jacks fail because the safety overload screw unscrews, which sets the lifting capacity of the jack at a much lower threshold, and the arm may not lift what you want to lift. This same author also stated that most safety overload screws are about two turns looser than the lowest point. I tried the biggest screwdriver I had (3/8 inch wide blade) with a wrench on its square shank. When my improvised screwdriver settled into the screw and its slot, I tapped on the head of the bolt to make sure it was fully seated in the slot. I used a wrench on the head of the bolt and the screw came out with no difficulty. I had tried to buy a big screwdriver, but I couldn't find one that big.

---

Replacement Parts For Floor Jacks

Craftsman Hydraulic Jack Parts & Models

Easily find manuals and spare parts on your phone while you're tinkering around the garage or garden.

---

Replacement Caster Wheels For Floor Jack

Warrior Jack Caster Wheel

There are items in your cart, are you sure you want to leave this site?

---

# Images | Replacement Wheels For Floor Jack - Floor Jack Saddle Bolt

Floor Jack Wheel Kit - Hydraulic Jack Repair Parts

Save

3 Ton Floor Jack Casters - 2 Ton Floor Jack Parts Diagram

Save